Jul 20, 2026 Leave a message

Common Faults in Key Components of Profile Extrusion Lines

1. Main Motor and Transmission System

Common Faults: Unstable main motor current fluctuations, motor failure to start, excessive bearing temperature rise, abnormal gearbox noise.

Causes: Uneven feeding, poor bearing lubrication/wear, burnt-out fuses, insufficient lubricating oil, or blocked suction pipe.

2. Extruder Screw and Barrel

Common Faults: Sudden drop in extrusion volume, material slippage and failure to advance, uneven plasticization.

Causes: Long-term wear of the screw leading to excessive clearance, material contamination by hard foreign objects, malfunction of a section of the barrel heater.

3. Die Head and Mold

Common Faults: Poor material discharge/blockage, yellow-black lines on the profile surface, material stagnation and carbon buildup in the flow channel.

Causes: Localized temperature runaway, dead zones in the flow channel design, failure to promptly clean residual material leading to degradation.

4. Auxiliary Equipment Components

Common Faults: No negative pressure in the vacuum system, traction slippage, uneven cutting surfaces.

Causes: Vacuum pump pipeline blockage/leakage, worn traction rollers, dull or worn cutting blades not replaced in time.

5. Temperature Control and Electrical System

Common Faults: Excessive temperature deviation, false triggering of over-temperature alarm.

Causes: Aging and misalignment of thermocouples, open circuit in heating coils, drift in temperature control module parameters.

PPR Pipe Extrusion Line

Send Inquiry

whatsapp

Phone

E-mail

Inquiry